Supports 75, , , , x dpi resolutions. Mustek ScanExpress P. Also please tell us if your scanner isn’t mentioned in this list at all. I tried with another usb-hub and now both phoenixes work ; I think the other hub’s power source is perhaps too weak to drive 2 phoenixes and a usb-stick. Obsolete, use test backend instead.

Uploader: Marg
Date Added: 13 June 2005
File Size: 13.73 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37237
Price: Free* [*Free Regsitration Required]

Haven’t been tested for a long time.

USB Cardreader for IPBOX [Archive] – Sat Universe

Not compatible to snapscan backend. Product id 0xb is supported by the gt68xx backend. Such features would be better implemented in a separate stand-alone tool.

Dynamic loading of shared-library backends. It has usb-connector in one end and a rsconnector at the other, like this one Thank you tetra for your reply.

USB – Lorenz Bell

Visioneer Serila XP Please contact me if you own such a scanner. However, someone started working on this scanner and some information is available see link.


This scanner is not supported. It has a led that flashes whenever I issue werial command and I thought “it’s working Only the USB scanners mentioned below are currently supported. SalvaMan Just insert both modules, only the right one will be used. The devices mentioned here are not supported by any SANE backend. Minolta Dimage Scan Dual I.

Network access to saned servers Comment: All resolution and mode supported, front- and backside side-by-side, with backside mirrored horizontally. Probably unsupported at the moment. However, it’s detected as mass storage device so lprenz mounting it is reported to work.

Mustek ScanExpress P. So, all in all, what went wrong in first place: Thank you for your help, nevertheless.

Not supported by SANE. One bulk-in, one bulk-out and one interrupt endpoint.

SANE: Backends (Drivers)

D So, I’m thinking this converter is not working as it should This is the same device as the 0x P, but the mode switch on the scanner is in the wrong position, you must move the switch. Also possibly Advent AWL See link for device data. The only way to see messages that were sent to the serial console while the cable was disconnected is to use the Lordnz Console Log function of the MP.


Is there anything else I can try, or shall I just get the hammer: Mustek ScanExpress CU. All buttons and sensors are exposed. Apparently all other devices are re-badged Artec scanners. Only the USB scanners mentioned below are supported. Trust Easy Webscan