Terminator and CAN bus cable shown are not included Additional Power-Point units may be added as required by your system’s power requirements. Shrink may be peeled back to expose pads for adding function wires. Generally, any of these can be used with any type of computer to communicate with any type of command station. Packaged in a smaller footprint the PR4 offers all the same great features as the PR3 it replaces. Ready, Power, Transmit, and Receive Small package size.

Uploader: Vudozragore
Date Added: 15 April 2017
File Size: 34.49 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 22301
Price: Free* [*Free Regsitration Required]

Search for troubleshooting guides. Many knowledgeable Digitrax users contribute to the Digitrax users “groups.

PR4 – USB to LocoNet Interface with Decoder Programmer – Released!

If a defect or accidental damage occurs, return the unit directly to Digitrax for service. Uxb a powered LCC bus. JMRI provides a wide variety of hardware-specific tools to assist in configuring the devices. These options do not take effect until the preferences are saved and JMRI is restarted. The command station may not immediately accept OpSw setting changes, so it may be necessary to “power-cycle” the command station, or to “put the command station to sleep” via the command station front-panel switch.

See below for more information on these. Intentional damage and customer modifications outside the scope of instructions provided with the product are not covered by this warranty.


Support: Digitrax LocoNet®

All configuration is stored internally in the nodes, and may be changed at any time on any system. Click here to send Digitrax Tech Support a message. For systems which do not provide a LocoNet command station, two additional options are supported. Please do not remove the shrink wrap protective sleeves from the Digitrax decoders. This problem can be avoided by ensuring that track power is on when switch messages are to be sent.

When enabled, this option greatly reduces the number of commands the LocoNet can handle each second, which can cause significant delays when you’re controlling signals, etc.

PS-S universal switching power supply is included. More PR4 setup information can be found on the PR4 setup page. Up to 16 Input Lines. This wide variety of behaviors can cause inconsistent or unreliable behavior of any device which relies on stationary decoder messages on the DCC track signal.

Support for Digitrax hardware products is available through Digitrax, Inc. Buffered inputs and outputs for full speed, error free data transmission. This includes speakers, wire, cables, battery covers, etc.

Accessory items that are not covered under the No Worries Warranty carry a 90 day warranty against defects in materials and workmanship. The PR4 makes decoder programming and interfacing your layout and computer easier than ever.

For more information on how to find those addresses, see this page. Up to 8 Input Lines. The LocoBuffer II and original LocoBuffer are no longer commercially available; their primary advantage now is that they use a traditional serial port, which may be the only suitable connection type available on some older computers.


When the command station gives this response, the switch command is not placed into the buffer and is forgotten.

It is recommended that all connections for LocoNet hardware use a prefix that begins with “L”, as other characters are normally associated locknet other hardware connection types. Your best investment — Keep your system up and running through ground loops, spikes, and surges.

JMRI Hardware Support – LocoBuffer-USB to LocoNet®

loconeh Rogue currents and ground issues can wreak havoc with your data, and even damage your LocoNet. Please give a complete description of the issue you are having. If a locomotive is sent to Digitrax, Digitrax will ship the entire package back, unrepaired. Up to 16 Output Lines.

This requires a separate LocoNet adapter for each connection. Includes drive for any combination of: