The same as the screen depth. Graphics cards and APUs. Enable DRI2 page flipping. The default is to enable Render acceleration. The default is to enable hardware acceleration.

Uploader: Shaktijind
Date Added: 11 September 2013
File Size: 49.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42648
Price: Free* [*Free Regsitration Required]

Only valid on PowerPC. Option “FBTexPercent” ” integer “.

Values other than and may aati make sense. The default value is on. Specify the RandR output s to use with zaphod mode for a particular driver instance.

Use this if the calculation is not correct for your card. The default value is 0x1E. This option is intended to be used in following cases: Option “SWcursor” ” boolean “.

Enable this option to force TV-out to always be detected as attached. Used to specify Mac models for connector tables and quirks. It reduces tearing at the cost of performance and has been known to cause instability on some chips. Used only when the DRI is enabled. Graphics cards and APUs.


The frequency parameter may be specified as a float value with standard suffixes like “k”, “kHz”, “M”, “MHz”. As an alternative, you can install a newer release of Ubuntu.

Note that using this option may damage your hardware. The output name is the RandR output name, e. The default is EXA. Pageflipping is supported on all radeon hardware.

HCL:AMD video cards – openSUSE Wiki

This driver provides 2D and 3D acceleration in your video hardware. This option allows you to enable to disable the DRI. The Radeon driver is already pre-installed in Ubuntu. Do not use EDID data for mode validation. Color tiling will be automatically disabled in interlaced or doublescan screen modes. Enable this option to skip the BIOS connector table parsing and use the driver defaults for each chip. This should be set automatically, but no one knows ,24 the limit is for which chip.

Unsupported chips Ubuntu It has three values: Should only be used when driver cannot detect the correct panel size. Option “ForceMinDotClock” ” frequency vldeo.


ATI Mobility Radeon X600

You may specify a semicolon-separated list of output name and filename pairs with an optional flag, “digital” or “analog”, to override the digital bit in the EDID which is used by the driver to determine whether to use the analog or digital encoder associated qti a DVI-I port.

Option “SwapbuffersWait” ” boolean “. This should greatly help power consumption, especially when idle. The default is to enable hardware acceleration.